Posting a toolpath

[ << first | < prev | next > | last >> ]

Posting a tool path is so simple. Just by clicking on a tool path group or individual operation you can instantly turn it into machine-ready code. You can also easily change the controller type or

Customizable Post
The posting format is fully customizable and is totally configurable the easy way - interactively. Shown below is the numbering that will be added to the posted code. As you change the settings the example on the right automatically changes.

Total Control
OneCNCXR gives you total control over the post format. One example of this ability is the Heidenhain configuration. The Heidenhain post can be automatically configured to allow the block form settings to be transmitted to the machine control. This block form allows viewing of the tool path at the machine control.

Tools for Posting
Machining statistics, including time estimates and tool path lengths, are produced automatically for each group or NC operation. You can also use the visualization and verification facilities to thoroughly check the operation before its posted. So only the verified programs are sent to the machine, thus eliminating waste of time, materials and money.

[ << first | < prev | next > | last >> ]